Programmer Access Code; Setting A Controller Id And Programmer Code - Nelson EZ 8600 Guía De Instalación Y Programación

EZ PRO RADIO SETUP
Controller ID- Every controller must have a unique ID. This will prevent a conflict if more than one controller is within range of
the radio signal. Write down the Controller ID for future reference.
WARNING: Do not select the same Controller ID for two controllers within 1 mile of each other. Improper radio operation
may result.
Programmer Access Code- Use the same Programmer Code for all of your EZ Pro controllers and EZ Command Remote
Programmers. This Code provides the security to prevent unwanted radio access.
REMINDER: Use the same Programmer Code on all of your EZ Pro controllers and EZ Command Programmers
Set a Controller ID and Programmer Code on the EZ Pro Controller
Set the Mode dial on the EZ Pro controller to the Program position. Turn the large dial on the EZ Pro controller to the Radio
Setup position. Use the SELECT
set these as you choose. Return the Mode dial to the OFF or Auto position
to move between Controller ID and Programmer Code. Use the ADJUST keys to
5