Pet-Immune Pir Motion Detector; Status Indication - Smanos X330 Manual Del Usuario

EN
Installing Magnet Contact
The magnet contact can be installed on doors, windows or any other objects that open
and close. When installing it on a window the sensor (large part) can be applied to the
frame and the magnet on the window itself.
Install the sensor and magnet in
closed position (within 1cm), when
they are separated more than
1cm, it blinks once.
Apply both parts with the included
double-sided tape. It is also
possible to apply the contact with
screws.
Avoid mounting sensors in areas
with a large quantity of metal or
electrical wiring, such as a furnace
or utility room. Always check if the
LED indicator blinks when opening
the door or window.
IMPORTANT: The magnet contact must be positioned on the right side of the sensor. There are
triangle marks on both transmitter and magnet which should be pointing towards each other.
27
X330-UM-EN-FR-ES-PT-V1.0.indd 27-28

Pet-Immune PIR Motion Detector

Overview
Double-sided tape stick place
Detection
window
Status indicator

Status Indication

Display
Blinks continuously
Blinks once
Blinks twice
Blinks once every 3 seconds
PCB Layout
Tamper switch
Infrared sensor
Infrared sensor: It detects the infrared rays released by human body motion, please
don't touch the surface and always keep it clean.
Tamper switch: Once the case is opened in working mode, the tamper switch is
triggered and then generates an alarm signal.
Test button
Bracket slot
Meaning
Self testing
Intrusion detected
Testing mode is finished, the detector
enters power-saving mode
Low battery, please replace the battery as
soon as possible
Status indicator
28
2016/8/19 15:41:14
EN