Brush Roll - Hoover WindTunnel Manual Usuario

Final filter
B
Headlight replacement
What to buy
This cleaner uses a T3 1/4 wedge
base bulb, HOOVER part no.
27313107.
Remove lens
_ isconnect cleaner from electri-
cal outlet. Do not use cleaner
without dirt cup or filters in place.
The final filter assists in returning
clean air to the room.
Remove dirt cup (Fig. 29).
Press on handle release pedal and
lower the nozzle so it is flat.
Using a Phillips screwdriver, remove
the four screws as shown and lift off
headlight lens (A). Lift out filter (B)
and replace.
Replace lens and screws.
Should you want to replace this filter,
ask for HOOVER part no. 38769032.
Disconnect cleanerfrom electrical out-
let.
Press on handlerelease pedal
lower the nozzle so it is
flat.
Using a Phillips screwdriver, remove
the four screws as shown and lift off
lens.
Pull old bulb straight out of
socket. Push new bulb straight
into socket until locked in place. Do
not twist bulb.
Excessive force is not required.
\
/
Replace lens
O eposition lens and secure with
the four screws.
Check agitator brush roll
When agitator brush roll brushes are
worn, the agitator brush roll should be
replaced.
To check condition of brushes, turn
cleaner OFF and disconnectfrom elec-
trical outlet.
12
O ove edge of a card across bot-
tom plate while turning agitator
brush roll. To maintain cleaning effec-
tiveness, replace agitator brush roll if
brushes do not touch card.