Powered Pet Hair - Hoover WindTunnel Manual Usuario

If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the check list below.
I What's the cause? What's the solution? 1
Not firmly plugged in. Plug unit in firmly.
No voltage in wall plug. Replace fuse or reset circuit.
What's the problem? Agitator brush roll brushes aren't turning.
[What's the cause? What's the solution? ]
Hard Surface mode selected on Surface Command _M Select a suitable carpet mode setting.
control dial.
Agitator brush roll is obstructed.
Disconnectcleaner from electrical outlet. Turn cleaner over and
remove any debris that has accumulated on the agitator brush
roll.
[What's the cause?
Dirt cup full.
Pre-filter screen dirty.
Incorrect carpet height setting.
Blockage in system.
What's the solution? j
Empty dirt cup.
Clean the pre-filter screen using the dusting brush tool.
Select another carpet height setting on the Surface Command T_
control dial.
dear blockage (see"Clearing blockages" section).
What's the problem? Cleaner hard to push.
[What's the cause? What's the solution? j
Incorrect carpet height setting. Select a hig_her carpet height setting on the Surface Command TM
control di_[.
[What's the cause? What's the solution? ]
Dirt cup full.
Pre-filter screen dirty.
Blockage in system.
Empty dirt cup.
Clean the pre-filter screen using the dusting brush tool.
Clear blockage (see"Clearing blockages" section).
What's the problem? Powered pet hair cleaning tool agitator brush roll won't turn.
I What's the cause?
Too much pressure being applied to tool.
Blockage in turbine channel.
Broken or worn belt.
Low cleaner suction.
What's the solution? ]
Continue using tool applying light pressure.
Remove blockage.
Replace belt.
Refer to items under "Cleaner won't pick up".
18