Power Button - Hoover WindTunnel Manual Usuario

Ocultar thumbs Ver también para WindTunnel:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DO NOT USE CLEANER OUTDOORS
or
ON DAMP or
WET SURFACES.
POWER button
OThe
POWER button (A) is located
at the top of the cleaner body.
Plug cord into electrical outlet.
To turn cleaner ON, press button once.
To turn cleaner OFF, press button again.
NOTE: THE CLEANER IS SHIPPED
WITH THE CONTROL
DIAL IN HARD
FLOOR POSITION.
BEFORE YOU
BEGIN TO CLEAN CARPETS, ROTATE
THE CONTROL
DIAL FROM HARD
FLOOR TO A CARPET SETTING.
Surface Command
TM
control
dial (some models)
The Surface Command
TM
control
(some models) is an automat-
ic height adjustment that allows you to
choose a cleaning mode for carpet
height or hard surface floors.
For nqaxinqumcleaning performance,
the following carpet height settings are
recornrnended:
Lowest setting: for all types of carpet,
Note: If the cleaner is difficult to push,
turn dial to the next higher setting.
Higher settings: for very deep pile car-
pet where easier pushing effort is
desired, while maintaining good clean-
ing performance.
HARD FLOOR The agitator is OFF; the
nozzle is set at LOW.
Surface Selector
(some
models)
Q
The Surface Selector (some
models) has three carpet height
settings and a hard floor setting. The
Surface Selector turns to allow you to
choose a cleaning mode for carpet
height or hard surface floors.
For rnaximurn cleaning performance, the
following carpet height settings are rec-
ommended:
Lowest setting: for all types of carpet,
Note: If the cleaner is difficult to push,
turn dial to the next higher setting.
Higher settings: for very deep pile car-
pet where easier pushing effort is
desired, while maintaining good clean-
ing performance.
HARD FLOOR MODE (with agitator
brush roll shut off) the nozzle is set at
LOW,
Automatic
agitator
brush roll shut-off
Q
he agitator brush roll will turn off
when the handle is in the upright,
storage position.
Agitator
brush roll control
OR
HiGH
_
otate control dial to "Carpet"
settings (A) to turn agitator brush
roll ON for cleaning carpet or rugs.
Rotate control dial to "Hard Floor" (B)to
turn agitator brush roll OFF when clean-
ing hard floors.
Transporting
cleaner
/
Q
To rnove your cleaner frorn room
to room, put handle in upright
position, tilt cleaner back on rear wheels
and push forward.
(Cont'd)
-_
07

Publicidad

Tabla de contenido
loading

Tabla de contenido