Sears Craftsman 917.28972 Manual Del Usuario página 33

as personas
molcar.
Jipo remolcado
tcci6n y la
stancia para
.A GASOLINA
da6os a las
a la hora de
a es extrema-
on explosivos.
garros, pipas y
;asolina apro-
sotina o aSadir
lrcha, dejar
:tecimiento de
tl interior de un
t contenedor
llama abierta,
un calentador
; al interior de
t o cami6n
mtico. Colocar
._l t erreno lejos
.mando.
mi6n o cara-
lo. Si no es
,o con un con-
de un surtidor
o del borde
abertura del
eraci6n de
dispositivo con
a ropa, cambi-
:le Io debido.
as y cerrar de
GENERALES
uina en un
)ernos apre-
trabaja en
)s de seguri-
;ionamiento
TROUBLESHOOTING CHART:
See appropriate section in manual unless directed to Sears service center
PROBLEM CAUSE CORRECTION
Weak or dead battery. 1 Recharge or replace battery.
1
2 Corroded battery terminals.
3 Loose or damaged wiring.
4 Faulty solenoid or starter.
1 Cutting too much grass!too fast.
2 Throttle in "CHOKE" position,
3 Build-up of grass, leaves and
trash under mower.
4 Dirty air filter,
5 Low oil leve!/dirty oil.
6 Faulty spark plug.
7 Dirty fuel filter.
8 Stale or dirty fue!,
Engine clicks but
will not start
Loss of power
Loss of power
Water in fuel.
10 Spark plug wire loose.
11 Dirty engine air screenlfins.
;12 Dirty/clogged muffler,
_,13 Loose or damaged wiring.
:14 Carburetor out of adjustment.
15 Engine valves out of adjustment.
Excessive vibration
1 Worn, bent or loose blade,
2 Bent blade mandrel.
Engine continues to
run when operator
leaves seat with
attachment clutch
engaged
3 Loose!damaged part(s), 3
2 Clean battery terminals.
3 Check all wiring.
4 Check/replace solenoid or starter.
1 Raise cutting height/reduce
speed.
2 Adjust throttle control.
3 Clean underside of mower
housing.
4 Clean/replace air filter.
5 Check oil level/change oil,
6 Clean and regap or change spark
plug.
7 Replace fuel filter.
8 Empty fuel tank and refill tank with
fresh, clean gasoline,
9 Empty' fuel tank and carburetor,
refill tank with fresh gasoline and
replace fuel filter,
10 Connect and tighten spark piug
wire.
11 Clean engine air screen/fins.
12 Clean/replace muffler,
13 Check all wiring.
14 See "To Adjust Carburetor" in
Service and Adjustments section.
15 Contact a Sears or other qualified
service center.
1 Replace blade. Tighten blade bolt.
2 Contact a Sears or other
qualified service center.
Tighten loose part(s).
Replace damaged parts.
1 Faulty operator-safety presence
control system.
1 Check wiring, switches and
connections. If not corrected,
contact a Sears or other
33