Freezer Features; Primary Features - Amana Manual Del Proprietário

Freezer Features
This book is intended to show tile variety of features that are available in tile product
What if These Features
line. If your refrigerator does not have all the options that are shown, many of these
are
Different from Mine?
options may be purchased by contacting the Consumer Aflkfirs Department. See contact
information on the cover of your manual.
Primary Features
CAUTION ]
To avoid property damage, observe the following:
• Do not force ice maker arm down or up.
• Do not place or store anything in ice storage bin.
WARNING ]
To avoid possible injury, including death, do not place glass items in Quick Chill Zone
TM.
Glass objects may shatter or
explode if exposed to extreme cold.
r
Automatic Dispensing Ice Maker
This ice maker creates the ice used in the dispensing
system.
Using Ice Maker for the First Time
• Confirm ice bin is in place !r @
and ice maker arm is down.
• After freezer section reaches
between 0 ° to 2°F (-18 ° to
-17 ° C), ice maker fills with
water and begins operating.
• Allow approximately 24 hours
after installation to receive first harvest of ice.
• Discard ice created within first 12 hours of
operation to verify system is flushed of impurities.
Operating Instructions
• Confirm ice bin is in place and ice maker arm is
down.
After freezer section reaches 0°
to 2°F (-18° to -17 ° C), ice
maker fills with water and
begins operating. You will
have a complete harvest of
ice approximately every 3
hours.
Stop ice production by raising
ice maker arm until click is heard.
• Ice maker will remain in the off position until arm is
pushed down.
Quick Chill Zone
TM
Quick Chill Zone
TM
provides a space for items to be
chilled or frozen quickly.
• To remove, lift Quick Chill
Zone
TM
from ice bin rails and
pull straight out.
• To install, reverse above
procedure.
l
Ice Storage Bin F_z::>(_
The ice storage bin is located below the automatic
dispensing ice maker.
To remove and install ice storage bin:
• To remove bin, remove Quick Chill
Zone
TM.
Raise ice maker _
arm to deactivate ice maker, j_r,__
• Lift front of bin and pull out to its full extension. Lift up
front of bin and remove.
To instal slide bin into rails below ice maker until
bin locks into place Drop me maker arm to activate
ice maker and replace Quick Chill Zone
TM.
IMPORTANT.- Ice bin must
be locked in proper place for _ _.i ["_
proper ice dispensing. If freezer _ _:
door does not close, bin is not ="
in proper location. Turn auger
driver as shown to properly align
ice bin with back of unit.
J
12