Amana Manual Del Proprietário página 20

Trouble Shooting
(continued)
TOPIC POSSIBLE CAUSE
SOLUTION
Refrigerator runs too
frequently (continued)
•W,T .66
Controls need to be adjusted.
Door is not closing properly
See the controls section in your owner's manual for assistance
in how to adjust your controls.
Refrigerator is not level. See Installation Instructionsfor details
on howto level your unit
Check for internal obstructions that are keeping door from
closing properly (i.e. improperly closed drawers, ice buckets,
oversized or improperly stored containers or foodstuffs, etc.).
Check gaskets for proper seal. Clean, if necessary, according
to cleaning instructions in owner's manual.
Water appears cloudy
Particles in water and/or ice
cubes.
Air or air bubbles in water.
Carbon dust from water filter cartridge.
This is normal when first using dispenser and will disappear
with use.
Initial water ejected through cartridge may contain harmless
carbon dust flushed from cartridge. Particles are safe for
consumption. Will disappear after the first few uses.
Concentrations of minerals in water will form Particles are not harmful and naturally occur in water supplies.
particles when water becomes frozen and
melts.
No indicator lights are lit on Freezer door is not closed. Verify that freezer door is closed. Power is removed from the
dispenser control (some control when freezer door is opened.
models) Refrigerator is not plugged in. Plug in unit.
Fuse is blown, or circuit breaker needs to be Replace any blown fuses. Check circuit breakers for any
reset, tripped circuits.
Power outage has occurred. Call local power company listing to report outage.
Refrigerator is in Sabbath Mode. See dispenser control instructions for further information.
Neither ice nor water is Freezer door is not closed. Verify that freezer door is closed. Power is removed from the
dispensed when pads are control when freezer door is opened.
pushed (some models) Controls are in lock mode. See dispenser control instructions for further information.
Water tank is filling. At initial use, there is an approximate 45-second delay in
dispensing while the internal water tank is filling.
Ice maker or ice maker-equipped unit has just Wait 24 hours for ice production to begin and for ice maker to
recently been installed or a large amount of ice restock after emptied.
has just been used.
Water filter is clogged or needs to be changed. Change water filter.
Ice maker is not producing Ice maker has just recently been installed or a Wait 24 hours for ice production to begin and for ice maker to
enough ice or ice is malformed large amount of ice has just been used. restock after emptied.
(some models) Water pressure is too low. Low water pressure can cause valve to leak. Water pressure
must be between 20 to 100 pounds per square inch to function
properly. A minimum pressure of 35 pounds per square inch is
recommended for units with water filters.
Water filter is clogged or needs to be changed. Change water filter.
Ice maker is not producing ice Ice maker arm is not in correct position Confirm ice maker arm is down. See Automatic Ice Maker
(some models) section in your owner's manual for details.
Household water supply is not reaching water Check water connection procedure in your Installation
valve Instructions.
Copper or plastic tubing has kinks. Turn off water supply and remove kinks. If kinks cannot be
removed, replace tubing.
Water pressure is too low. Water pressure must be between 20 to 100 pounds per square
inch to function properly. A minimum pressure of 35 pounds
per square inch is recommended for units with water filters.
Check freezer temperature. See the controls section in your owner's manual for assistance
on how to adjust your controls. Freezer must be between 0 to
2°F (-18 to -17°C) to produce ice.
Ice bin is not installed properly See ice bin section for proper installation and alignment.
2O