Velocity Adjustment; Unloading Your Marker - Tippmann X7 Phenom Manual Del Usuario

E

Velocity Adjustment

N
G
Each time you play paintball, check the velocity of your paintball marker with a chronograph
L
(an instrument for measuring velocity) prior to playing paintball. Verify that the marker's
velocity is set below 300 feet per second (or less if required by the playing field).
I
S
To adjust the marker's velocity, use the included ⅛" allen wrench in the holes of the velocity
adjuster. The velocity adjuster is located on the right side of the Upper Receiver, as shown in
H
Figure 7.
As shown in Figure 8, reduce the velocity by turning the velocity adjuster upward. To increase
the velocity, turn the velocity adjuster downward.
Figure 7: Velocity Adjuster Location

Unloading Your Marker

1. Eye protection designed for paintball use must be worn by the user and any person
within range.
2. Empty all paintballs from the Hopper. Turn the Hopper clockwise and lift from the
Cyclone Feed System. Remove all paintballs from the Cyclone Feed System.
3. Go to a designated firing area, remove the barrel sleeve, and move the Selector
Switch to a firing mode (see page 9).
4. Point your marker in a safe direction and fire several times to be sure there are no
remaining paintballs lodged in the chamber or barrel.
5. Return the Selector Switch to the Safe mode (see page 6).
6. Reinstall the Barrel Sleeve (see page 4).
7. Read the following Air Supply Cylinder Warnings and Safety Tips before removing the
air cylinder from your marker (removal instructions are on page 15).
Velocity Adjuster
Figure 8: Velocity Adjuster Detail
12