Barrel Sleeve Installation Instructions - Tippmann X7 Phenom Manual Del Usuario

E
N
G
L
THIS IS NOT A TOY. MISUSE MAY CAUSE SERIOUS INJURY OR
I
DEATH. EYE, FACE, AND EAR PROTECTION DESIGNED FOR
S
PAINTBALL MUST BE WORN BY THE USER AND ANY PERSON
H
WITHIN RANGE. WE RECOMMEND YOU BE AT LEAST 18 YEARS
OLD TO PURCHASE. PERSONS UNDER 18 MUST HAVE ADULT
SUPERVISION WHEN USING THIS PRODUCT. READ THE OWNER'S
MANUAL BEFORE USING THIS PRODUCT.
ALWAYS KEEP THE BARREL BLOCKING DEVICE INSTALLED
EXCEPT WHEN YOUR MARKER IS IN USE. ALWAYS MAKE SURE
THAT THE SELECTOR SWITCH IS IN THE SAFE MODE (SEE
INSTRUCTIONS ON PAGE 6) AND THE BARREL BLOCKING DEVICE
IS PROPERLY INSTALLED ON YOUR MARKER ACCORDING TO
THE INSTRUCTIONS TO PREVENT DAMAGE TO PROPERTY,
SERIOUS INJURY, OR DEATH.

Barrel Sleeve Installation Instructions

1. Insert the Barrel Sleeve onto the Barrel and loop the
cord over the top of the receiver and position at the
back of the grip as shown.
2. Adjust the cord length retainer up to the back of the
grip by pulling the cord through it until the retainer is
snug against the back of the grip. Keeping the cord
as tight as possible, leave just enough cord elasticity
to pull the cord/retainer up over the top of the marker
to remove the barrel sleeve for firing.
3. After the cord length is properly adjusted, lock the
cord length by tying a knot in the cord against the
back of the retainer as shown.
4. Before and after playing, inspect the Barrel Sleeve. Replace the
Barrel Sleeve if the sleeve or cord is damaged, or there is a loss
of cord elasticity.
5. Clean the Barrel Sleeve with plain, warm water and store out of sunlight in a dry area
when not in use.
WARNING
WARNING
4
Barrel Sleeve
Cord Length
Retainer