Getting Started; Battery Installation; Air Supply Cylinder Installation; Loading The Hopper And Cyclone™ Feed System - Tippmann X7 Phenom Manual Del Usuario

E

Getting Started

N
G
• Eye protection designed for paintball use must be worn by the user and any person
L
within range.
I
• Do not disassemble this marker while it is pressurized with air.
S
• Do not pressurize a partially assembled marker.
H
• Read each step completely before performing the step.
NOTE: Carefully hand start all threaded parts when assembling, and do not
overtighten, as this may potentially strip the threaded parts.
INSTALL THE AIR SUPPLY AND LOAD THE HOPPER WITH PAINTBALLS
ONLY AFTER YOU:
• HAVE A BARREL BLOCKING DEVICE INSTALLED (SEE PAGE 4)
• HAVE THE SELECTOR SWITCH IN SAFE MODE (SEE PAGE 6)
EYE PROTECTION DESIGNED FOR PAINTBALL USE MUST BE WORN
BY THE USER AND ANY PERSON WITHIN RANGE.

1. Battery Installation

: This marker can be fired in the mechanical (F) mode
NOTE
without a battery.
To install the battery:
a. Remove the battery door from the back of the grip by
pulling up and back on the tab as shown in Figure 2.
NOTE
battery, never pull it by the wires.
b. Install a 9 volt battery onto the battery clip.
c. Insert the battery into the grip with the battery clip at the
top, and wires routed as shown in Figure 3.
d. Replace the battery door with the tab down, press the
door and listen for the click as it locks back into the grip.

2. Air Supply Cylinder Installation.

Review
Air Supply Cylinder Safety Tips
mode (see page 6) and install the barrel sleeve (see page 4).
Lubricate the cylinder valve O-ring with Tippmann
cylinder valve into the air supply adapter at the back end of the marker grip. Twist the cylinder
clockwise into the air supply adapter until it stops. Use caution as the marker is now capable
of firing after you put the Selector Switch in a firing mode.
3. Loading the Hopper and Cyclone™ Feed System
The barrel sleeve must be installed (see page 4) and the Selector Switch in Safe mode (see
page 6).
a. Make sure that the Cyclone Feed System housing is clean and free of debris. Make
sure the Cyclone arms turn freely when the Manual Advance Lever is pushed (see
Figure 4).
: Whenever removing the battery clip from the
WARNING WARNING
(see page 14). Put the Selector Switch in Safe
grease, and then insert the air supply
®
8
Figure 2: Open Battery
Door
Figure 3: Install 9 Volt
Battery