Inglesina Cab 0+ Manual De Instrucciones página 31

fig. 21 Rotate the handle (A) to the most forward position. Make sure that the two
buttons (B) completely come out, after having arranged the handle to the proper
position.
fig. 22 Pass the diagonal segment (S2) of the car safety belt through the rear
guides (G).
CAUTION: make sure that the safety belts are well stretched and not twisted.
Only in this way it is possible to obtain the perfect anchoring of the Inglesina
Cab car system.
When the child car seat is used without the base, it is advisable to check that the
hatched red line on the symbol (P1) on the side of the child car seat is more or less
parallel to the ground.
CAB BASE
Install the Inglesina Cab Base on board of the car referring to the dedicated manual.
fig. 23 Install the Inglesina Cab 0+ child car seat to the Inglesina Cab Base only IN
THE OPPOSITE DIRECTION TO THE DRIVING ONE, until hearing both CLICK sounds
indicating the occurred hooking.
CAUTION: make sure that the child car seat is properly hooked on both sides,
trying to lift it.
fig. 24 Rotate the child car seat handle (A) to the most forward position. Make sure
that the two buttons (B) completely come out, after having arranged the handle to
the proper position.
fig. 25 Pass the diagonal segment (S2) of the car safety belt through the rear
guides (G).
CAUTION: make sure that the safety belts are well stretched and not twisted.
Only in this way it is possible to obtain the perfect anchoring of the Inglesina
Cab car system.
REMOVING THE CAB 0+ CHILD CAR SEAT FROM THE CAB BASE
fig. 26 Rotate the child car seat handle (A) to the vertical position. After having
removed the diagonal segment of the safety belt from the rear guides (G), act on
the child car seat lever (H) and simultaneously lift it from the Inglesina Cab Base by
holding it by the handle.
USE WITH INGLESINA EASY CLIP CHASSIS
For the correct use of the Inglesina Easy Clip chassis, refer to the dedicated manuals.
fig. 27 Properly open the chassis, following the suitable instructions. Holding the
Inglesina Cab 0+ child car seat by the handle, place it on the chassis on the central pin
making sure that the brakes are always properly engaged and that there is not any
carrycot or seat unit installed. Then, push the child car seat downwards until hearing
both CLICK sounds indicating the occurred hooking.
CAUTION: always make sure that the child car seat is properly hooked before
use.
fig. 28 To remove the child car seat, act on the rear lever (H) and simultaneously lift
it holding it by the handle.
31