Reiner jetStamp graphic 970 Manual De Instrucciones página 62

jetStamp graphic 970
Numbering machine range
Step width:
Repeats:
Downwards:
Leading zeroes:
Font for numbering machine
2 fonts may be selected for variable print data like date/time and numbering machine.
The font types can be changed via Settings-Font type.
Function of the numbering machine:
The numbering machine reading of a numbering machine is switched forward after
each printout according to the step width, repetitions and counting direction set.
Observe: The following configuration may lead to nonsensical numbering machine
readings:
- Print sequence „Print lines in sequence"
- Linked numbering machines with different repetitions each
60
Specify a value for increasing the numbering machine value.
Example: When entering a minimum value of 1, a maximum value of 10
and a step width of 2, counting will be 1, 3, 5, ..., 9.
The step width must not exceed the difference between the minimum
and maximum values!
The repeat factor is used when several printouts are t be printed with
the same number.
The basic setting is 1, i.e. the numbering machine increases the number
after each printout. When the value is set to 2, the numbering machine
increases the number after every second printout, etc.
The repeat factor can be set from 0 to 99.
The numbering machine does not count up if the value is 0. (0 is used
if you want to switch the numbering machine only manually using the
function position F)
The function down counts the numbers down (decrementing), e.g.,
1000, 999, 998,... .
Shows the counters with leading zeroes. If you activate leading zeroes,
the number of leading zeroes is determined by the number of digits of
the maximum (starting or end value).
The number of the digits corresponds to that of the maximum value.