Inserting Printing Cartridge; Test Printing - Reiner jetStamp graphic 970 Manual De Instrucciones

jetStamp graphic 970

1.2. Inserting Printing Cartridge

Inserting printing cartridge
Depending on ink type used, different Protective Nozzle Seals are required
(see "Replace Protective Nozzle Seal" Page 67).
Put the jetStamp graphic 970 in the base station
f
Turn the setting wheel
f
Keep the trigger button
f
3
Print carriage moves to the middle position.
Gently push the lock of print cartridge
f
be opened.
Open print cartridge flap
f
Take new print cartridge
f
15
nozzles .
Put the jetStamp graphic 970 on a fixed flat surface.
f
Insert printing cartridge
f
Close the print cartridge flap
f
Push the trigger button
f
3
Print carriage moves to the home position.

1.3. Test Printing

Test printing Fig.

The jetStamp graphic 970 is delivered with 4 factory-pre-set example print patterns.
WARNING
Danger of blinding in case of contact between ink and eyes.
Never hold the jetStamp graphic 970 with its nozzles pointing at the face of persons!
f
Turn the setting wheel
f
Put the device on a level surface to be printed on.
f
Press the trigger button
f
Example print pattern 1 is printed.
Fig. A +

7
to position 1.
1
pushed and take the device from the base station
13
to the right, until the print cartridge flap
11
.
12
from the packaging and remove protective film from the
12
.
11
.
1
.
A + C
7
to position 1.
1
.
B + D
4
.
4
.
11
can
GB
47