Electrolux DF42 Manual De Instrucciones página 39

Cleaning the water tank (only for
DW42X model)
Remove all
1.
inside the tank .
Remove the water tank
2.
small s helf, by lifting
it up and pulling it up
as drawing (1), then
repeat the procedure
with the water tank (2).
Loosen the
3.
carefully (3).
Remove the tank top
4.
cover (4).
Remove the tap of
5.
the tank by turning it
counterclockwise (5).
Using an object with no
6.
tips, remove the rubber
seal of the tank cover.
Remove the
7.
tap seal and clean all
parts with warm water
and mild soap. After
cleaning all the parts,
rinse them
running water.
Reassemble the rubber on tap and place
8.
the tap to the tank.
Place the rubber seal in the tank cover.
9.
Fit the lid on the tank using the side locks.
10.
To prevent leakage, tighten the tap
11.
clockwise and fit the tank firmly at the
door until there are no more gaps.
water
locks
rubber
under
WARNING
- Be careful to not reverse
the direction of fitting the
rubber part as shown in
the drawing.
- Make sure that the tank
insulating sleeve rests
against the inside of the
door after assembling
the tank.
Cleaning the drip tray (only in
DW42X model)
Remove the drip tray (B).
1.
Remove the drip tray grate
2.
from water dispenser (A).
Discard the water from
3.
the drip tray
necessary.
Clean the drip tray and the
4.
grate with warm water and mild soap.
Fit the grate in the drip tray.
5.
Attach the drip tray in the collector.
6.
whenever
B
A
39