Troubleshooting Table - Simmons VENTURE Manual De Instrucciones

TROUBLE SHOOTING TABLE
Never disassemble your laser rangefinder. Irreparable damage can result from unauthorized service
attempts, which also void the warranty.
If unit does not turn on, display does not illuminate:
• Depress power button.
• Check and if necessary, replace battery. If unit does not respond to key presses, replace the battery with a new, good
quality CR2 3-volt Lithium battery.
• While pressing Power Button, cover the objective lens to determine if the display is on.
If unit powers down (display goes blank when attempting to power the laser):
• The battery is either weak or low quality. Replace the battery with a new 3 -volt lithium battery (CR2).
If target range cannot be obtained:
• Make sure the display is illuminated.
• Make sure that the Power/Fire button is being depressed.
• Make sure that nothing, such as your hand or finger, is blocking the objective lenses (front of unit, below the
monocular) that emit and receive the laser pulses.
• Make sure unit is held steady while depressing Power/Fire button.
NOTE: The last range reading does not need to be cleared before ranging another target. Simply aim at the new target
using the display reticle, depress the power button and hold until new range reading is displayed. Specifications,
instructions, and the operation of these products are subject to change without notice.
Technical Specifications
SVL620B 6x 24mm
SVL620BT 6x 24mm
WARNING: THIS PRODUCT USES A LITHIUM BASED BATTERY. LITHIUM BATTERIES CAN OVERHEAT
AND CAUSE DAMAGE IF PHYSICALLY ABUSED. DO NOT USE BATTERIES THAT ARE DAMAGED OR
SHOW SIGNS OF PHYSICAL WEAR.
Simmons_VentureLRF_FullManual_5LIM_ResizedForBox.indd 5
625/571 450/411 250/228
625/571 450/411 250/228
+/- 0.5 yds Multi-coated
+/- 0.5 yds Multi-coated
4.2/106 5.8/165
4.2/106 5.8/165
5
7/2/19 3:25 PM