After Use - Clatronic FFR 2916 Instrucciones De Servicio

Freidora de fondue
Ocultar thumbs Ver también para FFR 2916:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 17
5. Insert the plug into 230V, 50Hz power socket. The „POWER" control lamp
GB
lights up.
6. Adjust the temperature control to approx. 130°C. The „HEAT" control lamp
lights up. Once the set temperature is reached, the LED switches off. With
a wooden stick (e.g. shashlik spit or wooden cooking spoon) you can test
whether the correct temperature has been reached. When this is inserted into
the oil, small air bubbles should rise up along the wooden stick. Alternatively,
you can place a piece of the food to be fried into the hot oil. If bubbles are
formed, the frying fat has reached the right temperature.
7. Place the pieces of meat on the fondue forks and then dip them into the oil.
Depending on the size of the meat pieces, the cooking process takes bet-
ween 4 and 7 minutes, i.e. the smaller the pieces of meat or other food are,
the faster they are cooked.
ATTENTION: Place the ingredients carefully into the hot oil. Care is required
as you are frying in an open vessel and it is not possible to avoid oil splashes.
Dry off the ingredients beforehand with a cloth.
8. Adjust the temperature with the regulator such that the oil simmers.
To switch the device off, fi rst turn the temperature regulator to OFF and remove
the plug from the socket.
Allow the frying oil a considerable time to cool down. Before continuing to use
the full frying pot, please ensure that it is no longer at a dangerous temperature.
1. Make sure that the plug is pulled out.
2. Wait until the deep fryer is completely cool before cleaning. Wait in any case
for 1 to 2 hours after use before using again to avoid burns.
3. Used oil should be poured out at the side.
4. Please do not immerse the device in water.
5. The lid can be pulled off upwards. This makes cleaning easier.
6. In order to replace the fi lters, pull the fi lter cover located in the lid of the
device upwards.
7. Clean the deep frying fat container, the lid and the housing with a damp cloth
and household detergent if necessary. Please do not immerse in water.
8. The deep frying basket can be cleaned in the usual way in soapy water.
9. Avoid using abrasive detergents or sharp objects to avoid damaging the deep
fryer!
40
6....-05-FFR 2916 40

After Use

Cleaning
20.10.2004, 17:23:16 Uhr

Publicidad

Tabla de contenido
loading

Tabla de contenido