Electrical Supply; Wiring Requirements; Connecting The Oven To The Mains - Fulgor Milano FCO 300 P TM 2F Instrucciones Para La Instalación Y Uso

The manufacturer can not be held responsible for any
damages to persons or objects caused by failure to observe
these instructions.
Before installing the oven have a qualified electrician verify
that your home is provided with adequate electrical service
and that the addition of the oven will not overload the circuit
on which it is to be installed. A separate three-wire single
phase 240V or 220-240V 50/60 Hz circuit is required If
the supply cord is damaged.
it must be replaced by the manufacturer its service agent or
similarly qualified persons in order to avoid a hazard.
WARNING
ELECTRICAL SHOCK HAZARD
• The electrical power to the oven circuit must be shut off
while line connections are being made
• Do not use an extension cord with this appliance
• Electrical ground is required on this appliance
• The free end of the yellow/green wire (the ground wire)
must be connected to a suitable ground This wire must
remain grounded to the oven
• A qualified electrician must install the appliance
• The oven must be earthed in accordance with the current
Australian Standard
• NOTE FOR AUSTRALIA: This appliance must be correctly
installed and serviced by a suitably qualified person,
strictly in accordance with AS/NZS 3000 wiring rules.
• The oven must be connected to the mains through a
multipole circuit breaker with a contact-to-contact gap
of a least 3 mm marking sure that the earth wire is not
disconnected.
• Such a device must be fitted to the power supply in
compliance with the regulations governing electrical
installations.
• The socket or switch must be easily reachable with the
oven fully installed.
• Failure to follow these instructions could result in serious
injury or death

Wiring Requirements

Before making connections make sure the power is off and
read and observe the following:
• A separate three-wire single phase 240V or 220-240V
50/60 Hz circuit is required for the oven
• The oven must be connected with COPPER WIRE ONLY.
• NOTE FOR AUSTRALIA: the oven must be installed to
conform with the current Australian Standard.
• Wire size (COPPER WIRE ONLY) and connections must
be suitable for the rating of the appliance per the current
Australian Standard.

4 - Electrical Supply

Connecting The Oven To The Mains

For connecting use a flexible rubber cable of the H05SS-F
type (3x2 5 mm2 min) remembering to make it long enough
to allow the oven to be removed from its housing unit when
maintenance work is required To connect the cable to the
oven proceed as follows (see figure):
1. Remove the two upper oven covers (1) by unfastening
the relative self-tapping screws (2). Unfasten the nut (3)
for the cable holder and feed the cable through the hole
leaving enough cable slack to to avoid stretching.
2. Remove about 12 cm of outside insulation from the cable
and shorten the two active wires (live and neutral) to
6cm. Leave the length of the earth wire as it is. Remove
about 1cm of insulation from each of the three wires and
then connect each wire to the terminal block. Ensure
that each wire is connected appropriately (L is for the
Live wire, N is for the Neutral wire and the earth wire is
indicated with the traditional dashed triangle).
3. Tighten the two cable holder screws so as to ensure that
the mains cable is held firmly in place.
1
3
2
A
1
Live
Neutral
A
Oven wiring
2
EN
7