Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3.0
Your generator can be connected at 230/400V three-phase.
The generator is set at the factory for a 400V three-phase voltage.
For safety double check the sticker placed at the end of the input
cable.
Should it became necessary to use an input current at 230V simply
follow these instructions (only on models with this option):
•
Put the main switch in the "OFF" position, disconnect the sup-
ply cable from the mains.
•
Remove the right side panel
•
Change the connections on the voltage change board, fol-
lowing the instructions on the label (see Fig. 1)
•
Make sure that the nuts holding the bridges are securely ti-
ghtened.
•
Re-assemble the right side panel.
For safety reasons and to avoid affecting the cooling conditions, do not
work with the side panels partially opened or completely removed.
4.0
4.1
HANDLE AND WHEELS ASSEMBLY (fIG. 2-3)
FIG. 2
FIG. 2
•
Unpack the welder;
•
Screw the two casters (D) to the machine;
•
nsert the axle (A) through the holes at the rear of the welder and slide a wheel (B) on to each end
followed by the retaining washers (C);
•
Assemble the plastic handle (E) using the screws provided (F);
FIG. 3
GENERATOR
•
Insert the axle (B) through the holes at the rear of the welder, slide the washers (D) and the wheels
(A) as shown in picture 3 and fix the wheels (A) using the supplied rings;
•
Mount the handle (E) on the supports (F) e fix the together with the spacers (H) to the front panel
using the provided screws (G);
SEPARATE WIRE FEEDER
•
Mount the handle (L) on the supports (M) and fix them using the provided screws (N);
•
Screw the four casters (I) to the wire feeder bottom;
•
Assemble the rotating support (O) on the top of the generator using the provided washers (Q) and
screws (P) and place the wire feeder on it.
•
Place the gas cylinder on the cylinder support and fix it with the chain provided: the cylinder must
be equipped with pressure regulator. For the connection between the generator and the separate
-ENGLISH-
vOLTAgE CHANgE
ASSEMbLY
M
I
L
N
O
F
P
H
Q
C
FIG. 1
FIG. 3
F
E
G
B
D
A
27
Publicidad
Tabla de contenido
