Cosatto Hootle Guia Del Usuario página 5

4 - seating your child into the car seat harness - all modes -1
Loosen the harness by pushing the adjuster button (a) in as you pull the harness straps
(b) forward as much as possible.
Important: Pull the harness UNDER the chest pads. DO NOT pull on the chest pads.
Unfasten the harness buckle by pressing the red button (c) and releasing the clips (d) and
open out the belts (e).
Place your child in the child car seat.
Fit the harness around your child and fasten the harness buckle by joining the clips (f)
and pushing them both into the buckle (g).
The harness must fit level with the top of your child's shoulders. It must not fit above or
below the shoulder line. (Refer to step 6).
5 - seating your child into the car seat harness - all modes -2
Check that the harness is not twisted. Pull the harness up (a) to tighten the lap
sections which is designed to fit low down on your child's body.
Pull the adjuster strap forward (b) making sure the harness is a comfortable but FIRM fit
around your child.
Finally, pull both chest pads down (c) from your child's shoulders onto their chest.
Note: The chest pads are an important safety feature. Never use the child car
seat without them.
6 - adjusting the shoulder strap position
(Group 0+ mode: 0 - 13kg) -1
Note: In Group O+ mode only the lower 3 shoulder strap positions (of 4) in the seat
back are used.
Recline the car seat to its most reclined position (position 3) to gain access to harness
connector. (See step 3).
Remove the headhugger (b).
Loosen the harness by pushing the adjuster button (c) in as you pull the harness straps
forward as much as possible (d).
Pull out the harness connector (e) from between the child car seat back and seat base.
Slide the harness straps off the harness connector (f).
Pull the harness straps through the child seat back (g).
7 - adjusting the shoulder strap position
(Group 0+ mode: 0 - 13kg) -2
Push the harness straps through the desired position in the seat back (a) and refit the
ends to the harness connector (b) making sure the strap ends are correctly fitted and not
twisted.
Refit the headhugger (c). Pull the harness strap at (d) to tension the harness.