Publicidad
Idiomas disponibles
Idiomas disponibles
Check the child car seat is securely fitted by lifting it slightly. Tighten the vehicle seat belt
if required.
Important: The position of the seat belt/lap strap buckle can affect the stability of the
child car seat. In an accident this could stop the child car seat from protecting your child
as well as it should. If, when the seat belt/lap strap belt is properly tightened, the buckle
lies in the position marked
position in your vehicle.
14 - changing the seat liners for group 1 mode from group
0+ mode - 1
Recline the car seat to its most reclined position (position 3) to gain access to harness
connector. (See step 3).
Remove the headhugger (b).
Loosen the harness by pushing the adjuster button (c) in as you pull the harness straps
forward as much as possible (d).
Pull out the harness connector (e) from between the child car seat back and seat base.
Slide the harness straps off the harness connector (f).
Pull the harness straps through the child seat back (g).
Slide the chest pads off the harness straps (h).
Remove the wedge from the lower seat liner (i) and refit the lower seat liner.
Store the Group 0+ Chest pads, headhugger and wedge in a safe place for future use.
15 - changing the seat liners for used in group 1 mode from
group 0+ mode - 2
Note: In Group 1 mode only the upper 3 shoulder strap positions (of 4) in the seat back
are used.
Push the Group 1 chest pad straps through the seat back (a) and fasten the connector
behind the seat back (b).
Push the harness straps through the chest pads and seat back (c) and refit the ends to the
harness connector (d) making sure the strap ends are correctly fitted and not twisted (e).
Fit the Group 1 upper seat liner (f).
Pull the harness strap at (g) to tension the harness.
16 - adjusting the harness (Group 1 mode: 9 - 13kg) - 1
Note: In Group 1 mode only the upper 3 shoulder strap slots (of 4) in the seat back are
used.
Recline the car seat to its most reclined position (position 3) to gain access to harness
connector. (See step 3).
Remove the upper seat liner (b).
Loosen the harness by pushing the adjuster button (c) in as you pull the harness straps
then try fitting the child car seat in another seating
Publicidad
