Memory- Cancellation Of All Measurements; Pc-Link Functions; Installation And Data Transmission - Microlife BP 3AC1-1 PC Manual De Instrucciones

Monitor automático de la tensión arterial

Tabla de contenido

Idiomas disponibles

30 sets of stored measurements – MR30: Value of the last measurement – MR29: Value of the measurement before MR 30

5.8.Memory– cancellation of all measurements

Attention!

Before you delete all readings stored in the memory, make sure you will

not need refer to the readings at a later date.

In order to delete all stored readings, depress the «M» button for at least

7 seconds, the display will show the symbol «CL» and 3 short beep

sounds will be heard to indicate deletion of stored readings.

Note:

If your last stored measurement was taken in the MAM mode, you will

see the «

» symbol approximately 3 seconds during the deletion

procedure. (The display will show this symbol during deletion of all stored

measurements, if the last measurement is taken in the MAM mode).

This device can be used in connection with a persoanl computer (PC) running the

Microlife Blood Pressure Analyser (BPA) software. The memory data can be

transferred to the PC by connecting the monitor via cable with the PC.

Insert CD into CD ROM drive of your PC. The installation will

start automatically. If not, please click on «SETUP.EXE»

Connect the monitor via cable with the PC – no need

to switch the device on. Three horizontal bars will

appear on the display and last for 3 seconds.

The bars will then flash to indicate that the connection between

computer and device is successfully made. As long as the cable is

plugged, the bars will keep flashing and buttons are disabled.

During the connection, the device is completly controlled by the

computer. Please refer to the «help» file for software instructions.

mmHg

Tabla de Contenido

Capítulos

Tabla de contenido