Miter Cut; Bevel Cut - RIDGID MS1050 Manual Del Propietário

Miter Cut

When a miter cut is required, loosen the miter lock knob,
depress the index spring, and move the saw to the
desired angle. Retighten miter lock knob. Do not stand in
front of the saw table. Move with the handle to the miter
angle to make the cut.
Move Feet
with
Miter Angle

Bevel Cut

When a bevel cut is required, loosen bevel lock knob and
tilt the blade to desired bevel angle. Lock the bevel lock
knob. Stand to the left side of the handle to make the cut.
Overriding the Bevel Stops
Bevel Lock
Use the 0° and 45° bevel stops for precise, repeatable
Knob
bevel indexing.
Bevel Index
Occasionally, when cutting a bevel or compound cut, you
Pin
may need to set the bevel angle a small amount beyond
the 0° or 45° bevel stop. This is very easily done by pull-
ing the bevel index pin out and locking the bevel knob.
Bevel Index Rear, Bottom
Stops
View From Back
19