Figure 11 Model 300Mb Motherboard - Federal Signal CommCenter D1 Serie Manual De Instalación Y Mantenimiento

Installation and Maintenance Manual
Storage chips should be installed starting at Priority Tone 1 and working downward. If, for example, only
four messages are required, have PT1 through PT4 sockets occupied and leave PT5 and PT6 open.
To remove a storage chip, gently pry it out of its socket. To install a storage chip insert it into the proper
socket on the printed circuit board as shown in Figure 11. Ensure that the notch on the edge of the new
storage chip is facing in the same direction as the old one, i.e., next to the resistors at the edge of the board,
and that all pins are properly inserted in the socket and not bent under.
18

Figure 11 Model 300MB motherboard

TB1
PRIORITY
TONE 1
PRIORITY
TONE 2
PRIORITY
TONE 3
PRIORITY
TONE 4
PRIORITY
TONE 5
PRIORITY
TONE 6
Model 300MB-SD CommCenter Series D1
V
O
L
I
J4 J5
J3
NC NO NC
NO NC NO
TONE6 TONE5 TONE4
1
R M R J7 M R M
J6 J8
NO J9 J10 J11
NC NO NC NO NC
TONE1 TONE2 TONE3
R M R M R M
J12 J14
J13
TB2
F1
J2
SW1
F2
290A7316