Measurements And Units (Mariner And Yachtsman); Selecting The Units Of Measurement (Mariner And Yachtsman) - Suunto MARINER Guía De Usuario

1.4 MEASUREMENTS AND UNITS (MARINER AND
YACHTSMAN)
The Wristop Computer supplies two units of measure: metric or imperial.
Metric Unit of Measure
°C
mbar
m
1.4.1 Selecting the Units of Measurement
To change the unit of measure displayed:
1. Check the mode indicator. If the mode arrow is not on TIME, PRESS the [Mode] button until the arrow is directly below
TIME on the Mode Indicator Bar.
2. PRESS the [Mode] and [Select] buttons simultaneously and hold in for 3 seconds. Field 1 will display "SET" momentarily
and then display "UNI" (Fig. 1).
WARNING: If the user presses the [Select] button (and does not hold for 2 seconds) while in the "UNI" setting mode,
the user will be in the Pressure Sensor Calibration. Refer to the next section for details.
3. PRESS the [Select] button and hold in for 2 seconds. Located to the right in Field 2, "mbar" or "inHg" will begin to
flash.
4. PRESS the [+] button to toggle between "mbar" and "inHg".
5. At the unit of measure desired, PRESS the [Select] button to move to the next unit. Located at the top right in Field 1,
°C or °F will begin to flash.
6. PRESS the [+] button to toggle between °C and °F.
7. At the unit of measure desired, PRESS the [Select] button to move to the next unit. Located to the right in Field 2,
or will begin to flash.
"ft"
8. PRESS the [+] button to toggle between "m" and "ft"
9. At the unit of measure desired, PRESS the [Mode] button to accept the changes. PRESS the [Mode] button again to
return to the main time mode.
Imperial Unit of Measure
°F
inHg
ft
8
"m"