Bearing Tracking Sub Mode - Suunto MARINER Guía De Usuario

• Field 3 displays the current time.
• The Outer Circumference graphically displays the North-South arrow where one-lit segment shows North and three-
lit segments show South.
The compass display is active for 45 seconds at a time. After this, the compass enters "sleep" mode and
an "---°" indicator appears in the field 2. Reactivate the compass by pressing the [-] button.
The Mariner provides a bubble level for the user to achieve a precise reading within ±3 degrees. The user centers the
liquid bubble to ensure the Wristop Computer position is level and takes a reading.
Note: Compass readings should be performed away from objects possessing sources of magnetism. Avoid buildings,
large metal objects, power lines, loudspeakers, electric motors etc.
Always take bearings in the open air, not inside tents, caves, or other shelters.

5.1 BEARING TRACKING SUB MODE

The user can select to change from the cardinal point mode to the bearing track mode and utilize the bearing lock feature
in this mode for tracking purposes (Fig. 20).
In the compass main mode:
1. PRESS the [Select] button and hold in for 2 seconds. Located in Field 1, "OFF" will begin to flash and the field 2 shows
the text "bEA" (bearing) (Fig. 21).
2. PRESS either the [+] or the [-] button to change the setting between "OFF" and "ON".
3. At the selection desired, PRESS the [Select] button to move to the next setting. Located in Field 2, the actual bearing
in degrees will begin to flash (Fig. 22).
4. Turn the Wristop Computer to the desired direction. Lock the bearing displayed by pressing the [-] button.
5. Adjust the locked bearing, if necessary by pressing the [Select] button and then adjusting the value with the [+] and
[-] buttons.
6. At the desired bearing to track, PRESS the [Mode] button to accept the changes and exit the setup program.
Note: If the user does not press any button for 1 minute in the setup mode, the display will automatically exit setup.
24