Connect The Usb Cable - HP SCANJET N6350 Guía De Instalación Inicial

3. Connect the scanner to a router (shown), Ethernet jack, or Ethernet switch using the
Ethernet cable.
4. Press the Power button to turn on the scanner.
5. If there is more than one HP Scanjet N6350 scanner on the network, locate the serial
number and IP address of the scanner to which you want to connect.
a. Press the Setup ( ) button on the scanner control panel, use
Network, and then press OK.
b. Use
c. Use
view the information without scrolling.
6. Complete the network connection.
a. When you see the Found Network Scanner dialog box, select the scanner with
the IP address you located in the previous step, and then click Next.
b. On the Computer Name dialog box, enter the computer name to be listed on the
scanner control panel, and then click Next.
c. On the Adding Device dialog box, click Next when the status bar indicates that
the new device has been added.
NOTE: This scanner supports a maximum of 20 network users. If there are
already 20 network users, you will see a Computer List Full dialog box. If
you have scanner administrator privileges, you can remove a computer from
the list and continue with the network installation.
TIP: You can also complete the network connection using the HP Scanner Tools
Utility. See the HP Scanner Tools Utility Help for more information.

Connect the USB cable

CAUTION: If you are installing in a Windows environment, do not connect the
scanner to your computer with the USB cable until prompted to do so during the
software install (see "Install the software" on page 2).
to select View Settings, and then press OK.
to scroll to the serial number and IP address settings, then press OK to
to select
Connect the USB cable 5