Publicidad
Idiomas disponibles
Idiomas disponibles
AriensDealers willprovide anyservice w hich may berequired
to keep yourunitoperating a tpeakefficiency. Should engine
service berequired, it canbeobtained froma AriensDealer
or theengine manufacturer's authorized s ervice center.
_h
ARNING: AVOID INJURY. Read and understand
entire Safety section before proceeding.
_
CAUTION: HOT SURFACES may result in injury.
DO NOT touch engine or drive parts which are hot
from operation. Allow parts to cool before servicing.
SERVICE
POSITION
1. Place unit on a flat level surface. ALWAYS stop engine.
Ensure unit is secure and will not tip over. Strap and
clamp onto lift if used.
2. Place steering levers in neutral and engage parking
brake.
3. Remove hex nut.
4. Tip seat forward (Figure 6).
_i
AUTION: Be sure footing is secure to
accomodate weight shift of seat when rotating it into
service position.
5. When service is complete, lower seat and secure with
hex nut.
4
5
1. Service Position
4. Parking Brake
2. Hex Nut
5. Battery
3. Steering Levers
Figure 6
OF3362
HYDRAULIC
FLUID
WARNING: HYDRAULIC FLUID can result in
severe burns. Fluid in hydraulic system can
penetrate skin and result in serious injury or death.
Be sure to stop the engine before doing any work
on hydraulic parts.
Keep body and hands away from pin holes or
nozzles which expel hydraulic fluid when under
pressure. Use paper or cardboard, not hands, to
search for leaks.
Ensure all hydraulic fluid connections are tight and
all hydraulic hoses and lines are in good condition
before applying pressure to system.
FOREIGN FLUID INJECTED INTO BODY can
result in gangrene. Fluid must be surgically
removed within a few hours by a doctor familiar with
this form of injury.
Check Hydraulic
Fluid Level
Operat_Range
_
--__
FULL Mark
OE0380
1. Start the unit and run it to operating temperature (about
10 minutes).
2. Cycle the control levers forward and backward two or
three times.
3. For units equipped with a hydraulic deck lift, raise and
lower the deck completely two or three times.
4. Shut OFF engine. Engage parking brake. Remove the
ignition key.
5. Put seat in service position. See SERVICE POSITION
on page 17.
6. Remove any dirt that may be around the cap/dipstick
on the hydraulic reservoir.
7. Remove cap/dipstick.
8. Check hydraulic oil level mark on cap/dipstick.
9. Add Mobil 1 Extended Performance 15W50 or
equivalent as needed (Ariens pin 00057100). Do not
overfill.
Change
Hydraulic
Fluid and Filter
NOTE: Change the hydraulic oil filter and hydraulic oil every
500 hours. Use Mobil 1 Extended Performance 15W50 Syn-
thetic Oil or equivalent for best component life (Ariens p/n
00057100).
NOTE: When changing the oil, only about 1.5 quarts (1.4
liters) will drain. The rest of the oil will remain in the pumps
and motors.
GB- 17
Publicidad
