Descargar Imprimir esta página

Ariens Promaster 144Z Manual Del Propietário página 26

Publicidad

Idiomas disponibles

Idiomas disponibles

PROBLEM
Engine
does not
crank.
Engine
cranks but
does not start.
Battery
light does not
light up when starting
engine.
CORRECTION
Disengage PTO.
Engage parking brake.
Clean and tighten battery cables (see
Clean Battery on page 19).
Charge battery (see Charging the
Battery on page 19).
See your Ariens Dealer.
Fill fuel tank (see FILLING FUEL TANK
on page 14).
Replace spark plug. Refer to Engine
Manual.
Clean or replace air cleaner. Refer to
Engine Manual.
Clean or replace fuel filter. Refer to
Engine Manual.
Refer to Engine Manual or see your
Ariens Dealer.
Charge battery (see Charging the
Battery on page 19).
Oil pressure
light
is
Refer to Engine Manual.
on.
PROBABLE
CAUSE
1. PTO engaged.
1.
2. Parking brake disengaged.
2.
3. Loose or corroded battery cables.
3.
4. Discharged battery.
4.
5. Faulty starter.
5.
1. Fuel tank empty.
1.
2. Faulty spark plug.
2.
3. Air cleaner is plugged or dirty.
3.
4. Fuel filter is dirty.
4.
5. Faulty engine.
5.
1. Discharged battery.
1.
1. Oil pressure is low.
1.
1. Ignition ground wire disconnected.
1.
2. Ignition switch failure.
2.
1. Operator presence switch not
1.
depressed.
2. Faulty PTO switch.
2.
1. Parking brake engaged.
1.
2. Transmission bypass levers open.
2.
3. Hydraulic oil level low.
4. Faulty hydraulic drive system.
,
4.
Engine
continues
to
run when ignition
key
is in the off position.
PTO or mower blades
do not engage
or shut
off.
Unit does not drive.
Connect ground wire to clean metal
surface.
Replace ignition switch (see your Ariens
Dealer).
Depress operator presence switch by
sitting on seat.
Check the electrical system to the
clutch for damage or wear. See your
Ariens Dealer.
Disengage parking brake.
Close transmission bypass levers (see
MOVING THE UNIT WITH THE
ENGINE OFF on page 15).
Add hydraulic oil (see Check Hydraulic
Fluid Level on page 17).
See your Ariens dealer.
GB - 26

Publicidad

loading