X-LITE X-803 Manual De Instrucciones página 21

6 ASSEMBLY OF THE CHIN STRAP COVERING
The right and left chin strap covering are different from each other (Fig.17B).
6.1 After identifying the left covering strap, insert the release mechanism of the chin
strap inside of it in line with the free end of the "hook and loop fastener" until it
comes completely out from the central slot. Press the free end of the strap over
the chin strap band in line with the "hook and loop fastener" and pull the strap to
stretch it out completely (Fig.17A).
6.2 Repeat these steps with the right covering strap.
6.3 Make sure the straps are secured by gently pulling them towards the inside of the
helmet.
6.4 If the release mechanism is the D-Ring type, check that the anti-fluttering snap
button on the left strap only is correctly placed past the two "D-rings" (Fig.17B).
7 ASSEMBLY OF THE INNER EXPANDING FOAM PADDING OF THE CHEEK PADS
7.1 Gently put the inner expanding foam padding inside the fabric lining of the left
cheek pad (Fig.15). Carefully spread out the padding while checking that there are
no wrinkles in the cheek pad fabric lining.
7.2 Repeat these steps with the right cheek pad padding.
8 CHEEK PAD ASSEMBLY
Warning: take the pad of the left cheek pad and make sure that the back snap
button "D", the fastenings "A" and the NERS safety lever "B" are correctly fas-
tened to the back frame of the fabric lining of the cheek pad (Fig.16).In addition,
check that the NERS lever is free to turn; then, place the lever in the opening
position.
8.1 Insert the rear guide "C" of the pad base frame in the corresponding plate between
the outer shell and the polystyrene inner shell. Then, pull the rear guide of the pad
base frame downwards and insert it in its corresponding cavity between the outer
shell and the inner polystyrene cheek pad (Fig.22).
8.2 Press the lower part of the left cheek pad to hook the front fastening "A" to its cor-
responding plate between the outer shell and the polystyrene cheek pad (Fig.14).
Then, make sure the pad base frame is correctly placed under the shell edge trim.
8.3 Insert the chin strap in the passageway of the cheek pad padding and press near
the rear snap fastener placed on the back to fasten it to the relevant seat on the
polystyrene cheek pad (Fig.13).
8.4 Press the pad of the left cheek pad against the polystyrene cheek pad and at the
same time turn it inwards to fasten the front and top hooks on its back. (Fig.12).
8.5 Press the safety lever upwards in line with the fastening area of the red strap to
turn it towards the cheek pad padding until it reaches its closing position. (Fig.11).
INSTRUCTIONS FOR USE
X803
21