Maintenance And Repair; Guarantee And Liability - akkuteam VAS 5901A Instrucciones De Uso

EMC and EMF
measures
Data protection
Maintenance and
repair
Guarantee and
liability
Safety inspection
ud_fr_ls_sv_01055 022007
It is the operator's responsibility to ensure that no electromagnetic interference
occurs in electrical and electronic devices.
EMC device classification (see rating plate or technical data)
Class B devices satisfy the requirements of the electromagnetic compatibility
directive in industrial and residential areas. This also applies to residential areas
where the power supply is provided by the public low-voltage network. Class A
devices can cause mains-borne and radiated interference in residential areas. If
this happens, the operator may be required to take appropriate measures.
The user is responsible for the safekeeping of any changes made to the
factory settings. The manufacturer accepts no liability for any deleted perso-
nal settings.
Under normal operating conditions the charger requires only a minimum of
care and maintenance. However, it is vital to observe some important points
to ensure it remains in a usable condition for many years.
- Before switching on, always check the mains plug and cable, and char-
ger leads/charging terminals for any signs of damage.
- If the surface of the charger housing is dirty, clean with a soft cloth and
solvent-free cleaning agent only
Maintenance and repair work must only be carried out by authorised person-
nel. Use only original replacement and wearing parts (also applies to stan-
dard parts). It is impossible to guarantee that bought-in parts are designed
and manufactured to meet the demands made on them, or that they satisfy
safety requirements.
Do not carry out any modifications, alterations, etc. without the
manufacturer's consent.
Dispose of in accordance with the applicable national and local regulations.
The warranty period for the charger is 2 years from the date of invoice.
However, the manufacturer will not accept any liability if the damage was
caused by one or more of the following:
- Use of the charger „not in accordance with the intended purpose"
- Improper installation and operation
- Operating the charger with faulty protection devices
- Non-compliance with the operating instructions
- Unauthorised modifications to the charger
- Catastrophes caused by the activities of third parties and force majeure
The operator is obliged to arrange a safety inspection of the device at least
once every 12 months.
The manufacturer recommends that the power source is calibrated during
the same 12 month period.
IV