Custom Insert Installation With Hood Trims - Thermador PROFESSIONAL VCIN36JP Manual De Instalación

Custom Insert Installation
with Hood Trims
NOTE: VCIN Custom Insert models have the Hood Trim
pieces included. VCIB Custom Insert model installations
that do not use the included Liner, must order the Hood
Trim pieces separately.
Trim Model
TRIM236
TRIM248
TRIM254
WARNING
To avoid electrical shock hazard, before installing, switch
power off at the service panel and lock the panel to
prevent the power from being switched on accidentally.
CAUTION
The hood weighs at least 60 lbs; therefore, it
requires at least two people to lift it safely.
Hidden surfaces may have sharp edges. Use
caution when handling the appliance. Failure
to do so may result in property damage or
personal injury.
Turn power OFF at the service panel. Lock service panel to
prevent power from being turned ON.
1. Prepare ductwork
a) Refer to "Ductwork Preparation" on page 6.
b) Install metal transition with backdraft damper so
that the flap opens up toward the ceiling. If
necessary, install thermal break and additional
backdraft damper (refer to "Hood Transition" on
page 8).
2. Build housing framework
a) Refer to "General Information" on page 4 for the
applicable model dimensions.
b) Refer to "Installation Preparation" on page 5 for
clearance specifications.
c) Build housing framework for applicable model
according to dimensions in "Preparing the Ceiling
Cutout and Housing" beginning on page 15.
3. Install blower motor
a) Refer to "Choosing the Correct Blower" on page 9.
b) Refer to "Blower Motor Installation" beginning on
page 10.
Insert Model
VCIx36JP
VCIx48JP
VCIx54JP
4. Install hood trim
Trim is only installed in models that do not use the optional
Custom Insert Liner. See "Custom Insert Installation with
Liner (optional)" on page 20 for liner installation
instructions.
a) Hold trim flush to the bottom of the housing.
Secure the trim to the hood with eighteen (18) x
(9.5 mm) screws, as indicated in Figure 29.
⅜" (9.5 mm)
x 18
6. Install the unit
a) Install the custom insert inside the custom housing.
b) Secure to the rear of the housing framework using
six (6) x 1'' (25.4 mm) mounting screws, as
indicated in Figure 30.
1" (25.4 mm)
x 6
''
Figure 29: Trim Installation
Figure 30: Rear Screws
English 19