Electrolux EKGE20C2NMS Manual De Instrucciones página 27

51 electrolux how to use
Setting Horno (Oven) Timer and
getting started
The Horno timer edition follows the
same procedures described on Only
Timer settings. However, to happen a
correct baking process, it demands
that at least its knob to be rotated.
Once countdown is over or cancelled,
the oven stops automatically the gas
feeding and baking process ends.
Timer countdown ends
When the countdown ends, 0:00
blinks and beep 02 sounds three times
with an interval of 5 seconds.
After this notication, the interface
returns to default mode automatically
or press Inicio / Cancela (Start/Cancel)
button to stop the notication manually.
Setting the Clock
Setting the clock (reloj) can be done
only when the timer is not enabled. To
do it, press and hold for two seconds
the button. The setting is done in two
steps:
First, set the two digits of hours (from
00 to 23). They will be blinking and
ready to be congured, press
until the desired number appears. A
single touch on each button
increases/decreases one hour. Holding
it, the variation is bigger: Each half
second holding the button, it varies 2
hours on the timer.
To navigate between hour and minutes
edition, press timer. This automatically
enables the setting of the desired
digits.
Rotating the knob to a temperature
enables Horno timer edition.
Note that it is possible to use the
oven without the timer. This makes
the baking process continuous.
horno (oven) timer
beep 2
If timer is associated with the
baking or grilling process of the
oven cavity, the timer also cuts the
gas feeding or shuts down the
resistance of the grill automatically
when countdown ends or when it is
cancelled.
While the notication is happening,
press Inicio/Cancela (Start/Cancel)
button to cancel it. It returns to the
default mode. Also, the interface
returns automatically to default
mode when notication ends.
Second, press to configure the
minutes (from 00 to 59). A single touch
on each button increases/decreases
one minute.
Holding it, the variation is bigger: Each
half second holding the button, it
varies 10 minutes on the timer. To
accept the displayed time, press
Inicio/Cancela (Start/Cancel)button.
After the clock edition has been
accepted, (:) blinks synchronously with
the seconds. Timeout: If the user does
not interact with the buttons, the time
edition is canceled and it starts
automatically with the previous shown
time.
Light of the cavity
Turning Luz (Light) ON / OFF of the
cavity can be done at anytime by
pressing light button. When it is on,
the button remains on either.
Error sound
When the interface is not on Standy
mode, the beep 03 informs that the
attempted interaction is not allowed at
the moment. This happens when the
non-enlightened buttons are
touched or when the timer exceeds
the allowed range. The exception is
the light button. Its interaction does
not depend on this feedback and can
be used at anytime.
Types of beeps:
: short beep right after each touch - allowed interaction.
beep 1
: 3 long beeps right when timer ends.
beep 2
: 2 short beeps right after the touch - not allowed interaction.
beep 3
: 1 long beep right after when electrifying happens and a baking process
beep 4
is started.
how to use electrolux 52
beep 1
beep 3