Troubleshooting - Sage the Barista Touch BES880 Guía Rápida De Inicio

Troubleshooting

PROBLEM
Water does not flow
from the group head.
No hot water.
Espresso only drips
from the portafilter
spouts or not at all.
Water doesn't come
through (the machine
makes loud noise).
18
POSSIBLE CAUSES
Water tank is empty.
Water tank is not fully inserted
and locked into position.
Machine needs to be descaled.
Coffee is ground too finely
and / or too much coffee in filter
basket and / or over tamping
and / or filter basket is blocked.
Coffee is ground too finely.
Too much coffee in the
filter basket.
Coffee tamped too firmly.
Water tank is empty.
Water tank is not fully inserted
and locked into position.
The filter basket may
be blocked.
Machine needs to be descaled.
Water tank is empty or water
level is below MIN.
There is an error on
purging setting.
EASY SOLUTION
Fill tank.
Push water tank down completely
to lock into place.
Perform descale cycle.
See below, 'Espresso only drips from
the portafilter spouts or not at all'.
Use slightly coarser grind.
Refer to 'Setting the Grind Size', page 10
and 'Over Extraction', page 13.
Lower dose of coffee.
Refer to 'Dosing', page 10 and
'Over Extraction', page 13.
After tamping, trim the coffee dose
using the Razor dose trimming tool.
™
Tamp between or 15–20kg of pressure.
Fill tank.
Push water tank down completely
to lock into place.
Use the pin on the end of the provided
cleaning tool to unblock the hole(s).
If the hole(s) remain blocked, dissolve
a cleaning tablet in hot water and
soak filter basket and portafilter
in solution for approx. 20 minutes.
Rinse thoroughly.
Perform descale cycle.
Fill tank.
Perform factory reset ('Settings' >
'Factory Reset').