Allmand ECLIPSE AB2400 Manual Del Operador página 15

Setting The Outriggers
WARNING
Rollover Hazard
• Raising the sign board without properly positioning
the outriggers could cause trailer rollover, resulting in
death or serious injury. Always extend the outriggers
on a firm, level, and stable surface before raising the
sign board.
1. Make sure the work site is suitable for the arrow board
trailer. See "Work Site Considerations".
2. Position the arrow board trailer to face oncoming traffic.
See "Using The Eyelets To Position The Trailer".
3. Disconnect the arrow board trailer from the tow vehicle.
See "Disconnecting the Trailer from the Tow Vehicle".
4. Level the arrow board trailer using the tongue jack:
• Turn the jack handle clockwise to raise the front of
the trailer.
• Turn the jack handle counterclockwise to lower the
front of the trailer.
NOTE: A jack may be required to level the trailer side-to-
side.
5. Lower the front of the trailer using the tongue jack (A,
Figure 10).
6. Set the rear outriggers (B, Figure 10) by unlocking (F,
inset) and removing (G) the locking pin securing each
outrigger to the trailer frame. Slide the outrigger down
until the top of the outrigger is flush with the top of the
outrigger bracket on the frame (H). Secure with the lock-
ing pin.
7. Raise the front of the trailer using the tongue jack (C,
Figure 10).
8. Set the front outriggers (D, Figure 10). (Follow the same
procedure as in Step 6.)
9. Fully raise the tongue jack. The trailer should now rest
solely on the outriggers, with the tires raised off the
ground approximately 3" (7,6 cm) (E, Figure 10).
G
F
A
C
Figure 10
Raising And Lowering The Sign Board
WARNING
Rollover Hazard
• Raising the sign board without properly positioning
the outriggers could cause trailer rollover, resulting in
death or serious injury. Always extend the outriggers
on a firm, level, and stable surface before raising the
sign board.
To raise the sign board:
1. Remove the locking pins (A, Figure 11) securing the sign
board in the transport position (B).
2. Turn the winch handle clockwise (C, Figure 11) until the
sign board is in the operating (vertical) position (D).
H
B
E
D
15
en