Residual Heat Indicator; Operation; Main Power Switch; Setting The Cooktop - Thermador MASTERPIECE Serie Guía De Uso Y Cuidado

Element
Triple element
ò
Bridge element
à
(only CET366NS)

Residual heat indicator

The cooktop is equipped with a residual heat indicator
for each element. It shows you which elements are still
hot. Avoid touching the indicated elements.
If an • is shown on the display, the element is still hot.
You could use it, for example, to keep a small quantity of

Operation

Main power switch

Use the main switch to turn on the electronic circuitry for
the control panel. The cooktop is now ready to use.
Turning the cooktop on
Touch the ON/OFF key until the
Turning the cooktop off
Touch the ON/OFF key until the
heat indicators will remain on until the elements have
cooled off sufficiently.
Note: The cooktop switches off automatically when all
the elements have been switched off for more than
20 seconds.
The residual heat indicator remains lit until the elements
have cooled down sufficiently.
the corresponding element symbol.
12
Turning on and off
On this element you can turn the medium and large heating rings off. The heating ele-
ment must be turned on.
Turning off the outer heating ring: Touch PAN SIZE. The
Turning off the middle heating ring: Touch PAN SIZE again. The
off.
When you turn the heating element on again, all of the heating rings will be on.
The Bridge element combines two individual heating elements into one long griddle
zone. This configuration is ideal for griddles and large pans.
Turning on the Bridge element: Touch BRIDGE. The
ing elements are now selected.
onds select the desired heat setting (1-9). The Bridge element and both individual
heating elements are now on.
Changing the heat setting: Touch one of the two
Bridge element, and set the new heat level within the next 10 seconds.
Turning off the Bridge element feature: Touch BRIDGE.
The heating elements will turn off after about 10 seconds, and the residual heat indica-
tor will appear.
indicator turns on.
"
turns off. The residual
"
/ is displayed next to
• œ
appears in both displays. Within the next 10 sec-
‹
$
food warm or to melt a chocolate coating. As the element
continues to cool, the display changes to
goes out once the element has cooled sufficiently.
The residual heat indicator will automatically come on
after a power failure. The display lights up for
approximately 30 minutes.

Setting the cooktop

This section will show you how to set the elements. The
table contains details on the heat settings for a variety of
dishes.
Setting the element
Select the desired heat level using the number keys
1 to 9.
Heat level 1 = minimum power
Heat level 9 = maximum power
Each heat setting has an intermediate level. This level is
indicated by . † and is set using
display will turn off.
ò
display will turn
ð
symbol will appear; both heat-
à
touch keys for selecting the
appears in both displays.
‹
. The display
œ
@ and A .