Replacing The Battery; Replacing The Fuses - Southwire 10040N Instrucciones De Uso

Operation

Replacing the Battery

WARNING:
To avoid electric shock, remove test leads from the meter
before removing the battery door.
1. When the battery drops below the
operating voltage, the symbol
will appear on LCD display. The battery
should be replaced immediately.
2. Remove the two Phillips screws from
the battery/fuse door located on the
back of the meter.
3. Remove door.
4. Replace battery with a fresh 9V battery.
5. Install the battery door and tighten the
screws.
WARNING:
To avoid electric shock, do not operate your meter until the
battery door is in place and fastened securely.
13
Operation

Replacing the Fuses

WARNING:
To avoid electric shock, remove test leads from the meter
before removing the fuse door.
1. Remove the two Phillips screws from
the battery/fuse door located on the
back of the meter.
2. Remove door.
3. Remove the old fuse from its holder by
gently pulling it out.
4. Install the new fuse into the holder.
5. Always use a fuse of the proper size
and value (UL rated 500mA /600V fast blow
for the 400mA range, UL rated 10A/600V
fast blow for the 10A range).
6. Install battery/fuse door and tighten
screws.
WARNING:
To avoid electric shock, do not operate your meter until the
fuse door is in place and fastened securely.
FUSE
9V BATTERY
FUSE
14