Continuity Test; Battery Test; Replacing The Battery - Southwire 10030S Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation

Continuity Test

WARNING:
Never test continuity on a live circuit.
1. Set the rotary function switch to
the
position.
2. Insert the black test lead into the
negative COM input jack. Insert the
red test lead into the positive
jack.
3. Touch the test probe tips to the
circuit or wire you wish to check.
4. If the resistance is approximately
30 or less, an audible signal will
sound. If the circuit is above 2000 ,
the display will indicate "1". The
resistance will be shown on the
display if it is below 2000 .
Diode Test
WARNING:
Never test diodes in a live circuit.
1. Set the rotary function switch to the
position.
2. Insert the black test lead into the
negative COM input jack and the
red test lead into the positive
input jack.
3. Touch the test probes to the diode
under test. Forward voltage will
indicate 400 to 700. Reverse voltage
will indicate "I". Shorted devices will
indicate near 0 and an open device
will indicate "I" in both polarities.
input
HOLD
600
OFF
600
200
200
20V
2000
µA
2000
20
mV
mA
200
200
mV
mA
2000
k
10A
200
1.5V
k
20
BATT.
k
9V
2000
200
CAT
III
300V
mA
10A
COM
!
!
For
30sec.
MAX
every
15 min
FUSED
Red
Black
Black
Probe
Probe
Probe
Forward Test
Reverse Test
9
Operation

Battery Test

1. Set the rotary function switch to the
1.5V or 9V BATT position.
2. Insert the black test into the negative
Wire
COM input jack and the red test lead
into the positive V input jack.
3. Touch the red test probe tip to the
positive side of the 1.5V or 9V battery
and the black test probe tip to the
negative side of the 1.5V or 9V battery.
4. Read the voltage in the display.
9V Battery:
1.5V Battery: >1.35V 1.22 to 1.35V <1.22V

Replacing the Battery

WARNING:
before removing the battery door.
1. When the battery drops below the
operating voltage, the
appear on the LCD display. The battery
should be replaced immediately.
2. Remove the two Phillips screws from
Red
the battery/fuse door located on the
Probe
back of the meter.
3. Remove door.
4. Replace battery with a fresh 9V battery.
5. Install battery door and tighten screws.
WARNING:
battery door is in place and fastened securely.
HOLD
2000
mV
200
mV
2000
k
10A
GOOD
WEAK
BAD
>8.2V
7.2 to 8.2V
<7.2V
To avoid electric shock, remove test leads from the meter
symbol will
To avoid electric shock, do not operate your meter until the
10
600
OFF
600
200
200
20V
2000
µA
20
mA
200
mA
10A
200
1.5V
k
20
BATT.
k
9V
2000
200
CAT
III
300V
mA
COM
!
!
For
30sec.
MAX
every
15 min
FUSED

Publicidad

Tabla de contenido
loading

Tabla de contenido