Skoda BEA 710 001 Instrucciones De Montaje página 8

PARK DISTANCE CONTROL
Advice
The part „Park distance control", ordering No. Škoda BEA 710 001, is intended solely
for the professional fitting by the contractual partners of Škoda Auto. The fitting
requires the use of special tooling and Workshop Manuals; because of that, the part
must not be sold to final users in a not mounted state.
- The park distance control, ordering No. BEA 710 001, is intended for vehicles Škoda
Fabia (5J), and it serves to facilitate the backing. The four sensors in the rear bumper
watch the distance between the vehicle and a possible obstacle. The driver is infor-
med on the extent of the free area by the acoustic signal from the loudspeaker.
- If an obstacle appears at a distance of 160 cm from the rear section of the vehicle,
it is signalled with short beeps at an interval of 1 second. Approaching the obstacle,
this interval gets shorter continuously. At a distance of 30 cm, the beeping changes
into an uninterrupted tone (signal STOP). Moreover, it is accompanied with jump
changes of the its pitch, see individual zones, fig. 15.
- The park distance control is not connected to data lines, and therefore, its diagnos-
tics by the instrument VAS is not possible.
When removing the individual parts and re-fitting them, proceed in accordance
with the Workshop Manuals. During the fitting, the car battery must be discon-
nected.
Remove the rear bumper and the panel of the threshold of the luggage compartment.
Loosen and tilt aside the side panel of lining of the luggage compartment on the side
behind the fellow traveller, and remove the lining of the C-pillar. If you have difficul-
ties while pulling the wires and fixing the control unit, you can remove the side panel,
if needed.
Before gluing the holders of the parking sensors and the control unit, clean and
degrease the respective places with the cleaners HHA 381 011 and HHA 381 010,
or similar ones. Let them dry for 10 minutes. Once the places have been pre-
pared in this way, do not touch them more for any reason; otherwise it is not
possible to guarantee the perfect affixing of individual parts!
The sensors can be painted in compliance with the colour of the vehicle. For painting,
use the enclosed template. During painting, proceed according to instructions and
recommendations of the paint maker.
Explanation to the figures:
No. 4 (hole of the dia. 18 mm)
- Drill the holes from the outer side of the bumper, and finish them from the inner
side. Remove possible burrs and clean the holes.
GB