Dometic WAECO MagicSafe MS660 Instrucciones De Montaje Y De Uso página 89

_MS660.book Seite 89 Montag, 2. August 2010 8:03 20
MagicSafe MS660
Deactivating MagicSafe without the hand-held transmitter
If you have misplaced the hand-held transmitter, the batteries are empty, or
the hand-held transmitter is damaged, you can deactivate the alarm system
with the electronic key.
➤ Open the door using the vehicle key.
✓ The alarm system triggers an alarm.
➤ Insert the electronic key in the socket.
✓ The alarm system is deactivated.
If the electronic key has also been lost, the alarm system can be deactivated
using the PIN code. To enter the 5-digit PIN code, proceed as follows:
➤ Open the driver's door using the ignition key, triggering an alarm by doing
so.
➤ Wait 30 sec. until the alarm stops.
✓ The status LED lights up continuously.
➤ Switch the ignition on for 1 sec. and off again within 5 sec.
✓ The status LED starts flashing.
➤ Count the number of flashes until the number agrees with the first number
of your PIN code.
1 flash = number 1, 2 flashes = number 2, ..., 9 flashes = number 9, 10
flashes = number 0.
➤ After the corresponding flashing signal, switch the ignition on for 1 sec.
and off again when the LED has gone out. This confirms the number.
✓ The status LED starts flashing again.
➤ Confirm all numbers in the PIN code in the same way.
Using MagicSafe
89