Dometic WAECO MagicSafe MS660 Instrucciones De Montaje Y De Uso página 95

_MS660.book Seite 95 Montag, 2. August 2010 8:03 20
MagicSafe MS660
✓ The status LED shows the last five saved alarm causes in the form of
flashing signals, in accordance with the following list:
Number of
flashes
1
2
3
4
5
7
8
9
10.8 Using the self-activation function
Self-activation (factory setting: deactivated) refers to the automatic arming of
the alarm system after leaving the vehicle. The ignition must be switched off
for this and the doors must be closed.
To set up self-activation, proceed as follows:
➤ Program software function 7 "Self-activation" to "On".
✓ The alarm system activates itself 10 sec. after the ignition was switched
off and a door was opened and closed again.
NOTE
I
If you have set the system to self-activate, the central locking does
not lock the doors, to prevent you locking yourself out of the car by
accident.
Cause of the alarm
Voltage drop sensor
Ultrasonic sensors (interior)
Door/boot contact switch
Bonnet contact switch
Ignition
Additional alarm input
Radio sensor
The battery in the hand-held transmitter is too weak
Using MagicSafe
95