Dometic WAECO MagicSafe MS660 Instrucciones De Montaje Y De Uso página 92

_MS660.book Seite 92 Montag, 2. August 2010 8:03 20
Using MagicSafe
Learning the hand-held transmitter
➤ Press the "COMFORT" button on the hand-held transmitter.
✓ The status LED goes out while the value is saved.
✓ If the status LED lights up continually again, then the hand-held receiver
has been learned and you can now proceed with the next one.
NOTE
I
Only exit learning mode when you have learned all the hand-held
receivers, electronic keys and radio sensors you wish to use. Hand-
held receivers and radio sensors which you do not learn during this
phase will be automatically unpaired from the system. They can
only be used once they have been learned again.
Learning the electronic key
➤ Insert the electronic key into the key holder on the dashboard.
✓ The status LED goes out while the value is saved.
✓ If the status LED lights up continually again, then the hand-held receiver
has been learned and you can now proceed with the next one.
Learning the radio motion detector (accessory)
➤ Switch the motion detector on using the switch.
✓ The read status LED on the motion detector flashes.
✓ The motion detector has been learned.
Learning the radio magnetic sensor (accessory)
➤ Disconnect the magnetic sensor contact (e. g. by opening a door secured
by the radio magnetic sensor).
✓ The read status LED on the magnetic sensor flashes once.
✓ The magnetic sensor has been learned.
92
MagicSafe MS660