Assembly Components - Castelgarden XM 130 Instrucciones De Uso

EN
1 GENERAL
This symbol indicates WARNING.
Serious personal injury and/or damage
to property may result if the
instructions are not followed carefully.
You must read these instructions for
use and the accompanying pamphlet
"SAFETY INSTRUCTIONS"
carefully, before starting up the
machine.
1.1 SYMBOLS
The following symbols appear on the machine.
They are there to remind you of the care and
attention required during use and maintenance.
This is what the symbols mean:
Warning!
Read the instruction manual and the safety
manual before using the machine.
Warning!
Watch out for discarded objects. Keep
onlookers away.
Warning!
Always wear hearing protectors.
Warning!
This machine is not designed to be driven
on public roads.
Warning!
The machine must not be driven in any
direction on slopes with a gradient greater
than 10º.
Warning!
Risk of burn injuries. Do not touch the
silencer/catalytic converter.
1.2 REFERENCES
1.2.1 Figures
The figures in these instructions for use are
numbered 1, 2, 3, etc.
Components shown in the figures are marked A, B,
C, etc.
A reference to component C in figure 2 is written
as follows:
"See fig. 2:C." or simply "(2:C)"
1.2.2 Headings
The headings in these instructions for use are
numbered in accordance with the following
example:
"1.3.1 General safety check" is a subheading to
"1.3 Safety checks" and is included under this
heading.
When referring to headings, only the number of the
heading is normally specified. E.g. "See 1.3.1".
50
ENGLISH
To avoid injury and damage to people
and property, do not use the machine
until all the measures in this instruction
have been carried out..

2.1 ASSEMBLY COMPONENTS

Components that are to be used at assembly are
included in the delivery. See fig. 1.
Supplied in bag:
Pos No. Designation
A 1 Towing plate
B 2 Screw with flange 8 x 20
C 2 Screw for battery
D 2 Nut for battery
E 4 Washer
F 2 Shoulder washer
G 4 Screw
H 2 Screw knob
I 2 Ignition key
J 1 Tension pin
K 1 Shim washer
L 1 Shim washer
P 2 Screw
Q 2 Nut
Supplied installed on the front axles:
Pos No. Designation
M 2 Circlip
N 2 Washer with internal lug
Secured to the implement lifter:
Pos No. Designation
O 2 Deck mount
2.2 ENGINE CASING
To fill with fuel and to inspect and maintain the
engine and battery, open the engine casing.
The engine must not be running when
the casing is opened.
2.2.1 Opening
1. Ensure that the control arms are in their forward
positions.
2. Raise the seat lock (2:S) and fold the seat
forwards.
3. Grasp the front edge of the engine casing and
fold up the casing (fig. 3).
2.2.2 Closing
Grasp the front edge of the engine casing and fold
down the casing (fig. 3).
The machine may not be operated
unless the engine casing is folded down.
Risk of burns and crushing injuries.
2 ASSEMBLY
Dimension
8.4 x 24 x 2.0
8 x 20
6 x 36
16 x 38 x 0.5
16 x 38 x 1.0
M10 x 35
M10