Ice Maker; Water Dispenser - Sub-Zero Designer Serie Guía Del Usuario Y Servicios

Ocultar thumbs Ver también para Designer Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation

Ice Maker

To operate the ice maker:
1
To activate the ice maker, touch
screen. A single highlighted cube indicates the ice
maker is active. Three highlighted cubes indicate the
max ice feature is active.
2
To deactivate the ice maker, touch
are highlighted.
After initial start-up, discard the first few batches of ice.
The ice may contain impurities from new plumbing con-
nections.
Max ice increases ice production up to 30% for a 24-hour
period. During that period, some components may run at
a higher speed resulting in a unique audible tone. This is
typical and will revert back after 24 hours or when the ice
container is full.
If ice is not used regularly it may fuse together. To avoid,
discard the ice and allow the ice maker to replenish.
Deactivate the ice maker if the ice container is removed for
an extended period. The unit is equipped with a 3-minute
delay after the ice container has been removed, to ensure
cubes are not ejected before the ice maker is deactivated
or the ice container is reinstalled.
16 | Sub-Zero Customer Care 800.222.7820

Water Dispenser

The water dispenser is located inside the refrigerator on
the left wall. Refer to the illustration below.
on the options
To dispense water:
1
until no cubes
2
The chilled water reservoir tank holds approximately 32 oz
(1 L)
water to refrigerator temperature during the original fill and
after a large amount of water is dispensed.
To fill the water tank:
1
2
3
Water dispenser
Press a glass against the dispenser to activate the flow
of water.
The flow of water will stop when the glass is pulled
away.
of filtered water. It may take several hours to chill the
Press a glass against the dispenser until water begins to
flow. A safety feature is incorporated into the dispenser
to limit continuous water flow to 60 seconds.
If water does not dispense within 60 seconds, remove
the glass, then reapply to the dispenser until water
begins to flow.
Once the tank is full, discard the first few glasses of
water. It may contain impurities from new plumbing
connections.
WATER DISPENSER

Publicidad

Tabla de contenido
loading

Tabla de contenido