Wolf Garten Robo Scooter 300 Instrucciones De Funcionamiento página 85

Screen Setting
Islands
¤ ¥ ¥ §
(Default =
  
Near Wire Follow
¤ ¥ ¥ ©
(Default =
 
Max Near Wire
Follow Distance
¤ ¥ ¥ 
(Default =
changed based on
the lawn area)
Min Near Wire
Follow Distance
¤ ¥ ¥ 
(Default =
¦
Near Wire Follow
¤ ¥ ¥  Test
Rain Sensor
¤ ¥ ¥ 
(Default =
 
Rain Sensor
Sensitivity
¤ ¥ ¥ 
(Default =
§ 
Edge On/Off
¤ ¥ ¥ (Default =
 
• In rare cases, you may notice that the mower unnecessarily circles
around a Perimeter Island, while searching for the Base Station.
• The Islands option helps overcome this situation. To avoid such
cases, turn the Islands feature on.
• When the Islands feature is set to on, the mower will execute a
)
special method of searching for the Base Station. As a result it
may take the mower longer time to arrive to the Base Station.
• See also menu P006 below.
• When the unit completes its operation, or when the 'Home'
button instructs it to go to Base, it drives itself to the Base Station.
• The unit drives along the Perimeter Wire with a dynamic offset
)
(not centered) to prevent wheel tracks along the same path. This
return behavior can be turned off.
• The maximum distance the unit will drive from wire when
returning to the Base Station.
• The distance does not represent actual units of measurement.
• The offset Distance values range from 1 to 12. They represent
different distances from the wire.
• The higher the Distance setting, the smaller the probability of
tracks along the perimeter.
• Perimeter Islands that are relatively close to the Perimeter Wire or
narrow passages may prevent the mower to complete its drive to
the Base Station with 'Near Wire Follow' mode. In such cases
decrease the distance to allow the mower to complete the drive
to the Base Station.
• The minimum distance the unit will drive from wire when
returning to the Base Station.
• The larger the number, the bigger the distance the mower will
drive from the wire while returns to the Base Station.
)
• Enables to test the mower in the max 'Near wire Follow Distance'
that is defined in menu P004.
• If the mower is not able to complete the drive in 'Near Wire'
mode smoothly, then it is recommended to reduce the max
distance set in menu P004.
• The Rain Sensor feature halts operation on rainy or highly humid
weather.
• This is recommended for the health of the lawn. However,
)
mowing wet grass does not present any technical problem.
• The unit detects rain when the current reading value is below the
set Sensitivity value and postpones operation.
• The higher the Sensitivity setting, the more sensitive the unit is to
)
rain detection.
• The Edge is a special mode, in which the unit follows the
perimeter wire for complete and accurate owing of the lawn
edges.
• In lawns where the edge is not maintained well and the mover
fails to complete the drive along the edge of the lawn, it is
)
recommended to set the Edge to 'Off'.
• Setting the Edge to 'Off' disable the Edge mode in automatic
departures from the station, but still allows the Edge mowing
when pressing the 'Edge' mode button on the operating panel.
Description Options
  ¨   
  ¨   
¦  ¦ §
¦  
  ¨   
¥  © ¥
  ¨