Multiplex MULTImate V 1.42 Manual De Instrucciones página 26

P B
ART
D
ETAILED LIST OF THE PROGRAMMING
1. S
WITCHING THE
O
VERVIEW OF THE MAIN MENU LEVELS
Action & Display
...MULTImate....
...push short!
1 MPX MULTImate
2 RX-SYNTH IPD
3 RX-SYNTH M-PCM
4 RX M-LINK
5 RX run
6 MULTIcont BL
7 MULTIcont SBEC
8 Servo prog.
9 Servo test
10 Impuls meas.
11 MPX Sensors
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de
Operating Instructions - MULTImate – V1.42
,
TEST AND SET
MULTI O
MATE N AND
...switch off..
L
Note:
• In each case the following series of screen-shots start and end at the main menu level, and
show the screen displays generated by the MULTImate.
• Please see the screen-shots printed above for details of the MULTImate's power-on and
power-off procedures.
-
UP FUNCTIONS
O
FF
Explanation
Power-on procedure:
•
twice in succession
•
MULTImate is switched on when
"1 MPX MULTImate" appears in the main menu
Note: If you press the 3D digi-adjustor only once, the
unit switches itself off again after about six seconds.
This defined power-on procedure eliminates the risk of
accidentally turning the unit on, and thereby drawing
current unnecessarily.
Power-off procedure:
•
back to the main menu level until the screen
displays "...Switch off... L" or "...Ausschalten.. L",
then
•
The screen goes dark, and the MULTImate is
switched off.
Note: If you do not use the MULTImate when switched
on, it automatically switches itself off again after about
1.5 minutes.
Seite 3/22