Multiplex MULTImate V 1.42 Manual De Instrucciones página 30

2-5 Error count
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de
Operating Instructions - MULTImate – V1.42
2-5 Go back
...to RX IPD
2-5 RF errors
0
2-5 Volt. errors
0
2-5 Sgin. errors
0
2-5 Clear errors
L
2-5 Start errcnt
2.0 sec
2-5 Low voltage
4.0 Volt
Display of recorded RF errors*
Display of recorded low-voltage errors*
Display of recorded signal errors*
* The counter can only be read out if the errors were
stored in the receiver before it was switched off: this is
accomplished by briefly pressing the SET button on the
receiver when errors are indicated.
Erase error counter completely:
Selecting the error counter start time
(how many seconds are to elapse after switching the
receiver on and the start of error recording?):
•
Can be selected from 0.2 sec to 24.0 sec.
•
Alter value using and
the set value with
Selecting the voltage threshold for low voltage errors
•
Can be selected from 3.5 Volt to 5.0 Volt
•
Alter value using and
set value with
or , confirm
or , confirm the
Seite 7/22