Multiplex MULTImate V 1.42 Manual De Instrucciones página 33

3-4 Error count
3-5 RX type
PCM12 35A V2.68
3-6 RX reset
L
3-7 Send data
L
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de
Operating Instructions - MULTImate – V1.42
3-4 Go back
...to RX M-PCM
3-4 RF error
0
3-4 Volt. err.
0
3-4 Sign. err.
0
3-4 Clear errcnt
L
3-4 Low voltage
4.3 Volt
Display of recorded RF errors*
Display of recorded low-voltage errors*
Display of recorded signal errors*
* The counter can only be read out if the errors were
stored in the receiver before it was switched off: this is
accomplished by briefly pressing the SET button on the
receiver when errors are indicated.
Erase error counter completely:
Selecting the voltage threshold for low voltage errors
•
Can be selected from 3.0 Volt to 6.9 Volt
•
Alter value using and
with
Display of connected receiver type
•
Description (PCM12)
•
Frequency band (35 MHz A-band)
•
Software version (V2.68)
If you wish to reset the receiver to the factory default
settings:
Caution:
The previously set values and / or data must be sent
to the receiver via this menu point, otherwise they
will not take effect.
The only exception from this is the menu point:
"3-6 RX reset"
• To send the selected data:
or , confirm the set value
Seite 10/22