Manta MES1201H Manual De Usuario página 11

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

ASSEMBLY ESCOOTER INSTRUCTION
1.
The steering wheel to be raised to the top and fasten the locking device.
2.
Shopping cart, you must screw the four supplied screws.
3.
Then adjust the height of the seat.
4.
The last step is to adjust the front lighting.
CHARGING METHOD
1.
Connect the charger is located at the bottom of the
vehicle (see figure).
2.
Connect the charger cable to the hole (make sure
that the components are dry).
3.
The charger light will light up in red during charging.
When the color will change to green, the battery
is fully charged and you should disconnect the
charger, otherwise it will have a negative impact on the battery life.
4.
Finish charging by covering the charging port, to protect it from moisture.
CHARGING SAFETY TIPS
If the battery will not charge at the right time, can cause damage. Full battery discharge risk
reduction of its viability.
Please use only original batteries, chargers and cables, it is necessary to protect the battery
from overcharging.
Please make sure that the charger cables have been properly connected and charging is
done in a well ventilated environment.
The charger should be used in a dry environment. Charger and cables must be protected
from contact with water, because there is a risk of electric shock. Do not touch the device
with wet hands. If any error occurs while charging, disconnect the charger from the power
supply.
When disconnecting the charger from the power supply depends on the pull by the plug,
not the cord.
Do not allow to contact the charger and cables with sharp or hot objects.
MES127 – EN
CHARGING
9

Publicidad

Tabla de contenido
loading

Tabla de contenido