Common Terms; Installing The Ecosalt2; Installing The Power Supply - Davey EcoSalt 2 DES2-15E Manual Del Usuario

COMMON TERMS

Algae Microscopic forms of plant life which enter the pool by rain, wind and dust. There are
numerous varieties – some are free floating whilst others grow on walls and in cracks
and come in different colours. Some are more resistant to chemical treatment than others.
Bacteria The germs that contaminate your pool. Introduced by swimmers, dust, rain storms
and other elements.
Balanced water The correct ratio of mineral content and pH level that prevents pool water from being
corrosive or scale forming.
Chloramines Compounds formed when chlorine combines with nitrogen from urine, perspiration, etc.
Chloramines cause eye and skin irritation, as well as unpleasant odours.
Chlorine demand The chlorine required to destroy germs, algae and other contaminants in the pool.
Chlorine residual The amount of chlorine remaining after chlorine demand has been satisfied.
This is the reading obtained with your test kit.
Cyanuric acid Also known as stabiliser or conditioner. It reduces dissipation of chlorine by direct
sunlight.
Liquid acid Chemical used to reduce the pH and total alkalinity in the pool water, and for cleaning
Sanitiser cell.
ppm An abbreviation for Parts Per Million the accepted measurement of chemical
concentration in swimming pool water. 1 ppm = 1 mg/L.

INSTALLING THE EcoSalt2

INSTALLING THE POWER SUPPLY

Select a convenient well-ventilated location within one metre of filter equipment and mount the power supply
vertically onto a wall, or post at least as wide as the EcoSalt2 power supply itself. Davey recommends that
the power supply shall not be located within 1.5m (5 feet) of the pool water. Plug pump and chlorinator power
supply into a suitable weatherproof power outlet/controller. Where applicable, some model variants have a
3-pin socket on the underside of the power supply, provide pump power. The unit must be kept away from
acid and other chemical storage areas. Acid and chemical vapours will corrode the electronics inside the unit.
It must also be kept away from heat sources. Good ventilation is necessary for correct operation.
Two self-tapping screws and wall plugs have been provided for fast and simple installation.
Use a 6mm (¼") masonry drill bit when fitting Power Supply to a brick or concrete wall. When mounting to a
post drill pilot holes and fit screws provided. Holes should be level and 164mm (6½") apart. Once screws are
in position simply hang EcoSalt2 power supply via mounts on back of unit. For adequate weatherproofing, the
wall or post that EcoSalt2 is mounted to, should be flat and at least as wide as the EcoSalt2 power supply.
230V POWER SUPPLY
Suction Line
PUMP
ACCESSORIES
FILTER
6
Return to pool line